Cisco Remote PHY Shelf 7200 Software Configuration Manual And Command Reference page 29

Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Table 4: Parameters for time interface and PTP domain configuration
Parameter
ptp r-dti [id]
description
ptp-domain [id]
local-priority [value]
priority1 [value]
priority2 [value]
mode [value]
profile [value]
clock-port [id]
state [value]
ethenet [value]
clock source [ip] gateway
[ip]
clock alternate-first
transport [value]
transport cos [value]
transport dscp [value]
local-priority [value]
sync interval [value]
announce interval [value]
delay-req interval [value]
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Description Value Range
1-64
R-DTI name or
description
Domain number of IEEE 0-127
1588
Set local priority 128
Set priority1 0-255
Set priority2 0-255
R-DTI mode other, slave master
Set PTP ITU-T profile default/G.8275.2
Configure clock port 1-32
Set Ethernet port admin other, up, down, testing
status
Set Ethernet port for clock 0-32
port
Set clock address ipv4 address, ipv6 address
Select alternate source
first
Set transport other, ipv4, ipv6
encapsulation
COS of 802.1Q 0-7
DSCP of IP differentiated 0-63
services
Set local priority 1-255
Set an interval for sync 0-7(-7 -0)
packets
Set an interval for 0-3(-3 -0)
announcement packets
Set an interval for PTP
delay-req packets0-7(-7
-0)
Configuring Time Interface and PTP domain
Default Value
128
128
255
slave
default
up
The default value is clock
port index
ipv4
6
47
128
17