Configureloadbalancingwithdynamicbondinggroupenabled; Enable Load Balancing For Docsis 3.0; Enable Docsis 3.0 Static Load Balance - Cisco Remote PHY Shelf 7200 Software Configuration Manual And Command Reference

Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
To display the detailed channel list information of dynamic bonding group, use the show derived-config
interface wideband command as shown in the following example:
Router# show derived-config interface wideband-Cable 3/0/1:1
Building configuration...
Derived configuration: 113 bytes
!
interface Wideband-Cable3/0/1:1
cable bundle 255
cable rf-channels channel-list 0-7 bandwidth-percent 1
end
Check the usage of bonding group resource using the show cable dynamic-bonding-group quota command.
Router# show cable dynamic-bonding-group quota controller 3/0/1
slot/subslot/ctrlr: 3/0/1
Total BG number: 128
Used BG number (static/dynamic): 6(1/5) Available BG number: 122
Available BG list port: 0, 6-29, 31-127
Check the reclaimed bonding group using the show cable dynamic-bonding-group reclaim-history summary
command:
Router# show cable dynamic-bonding-group reclaim-history summary
BG ID BG Name
list
24835 Wi3/0/1:2 16
24832-2484

ConfigureLoadBalancingwithDynamicBondingGroupEnabled

If you want to use load balancing with the DBG enabled, we recommend that you configure the load balancing
as shown here.

Enable Load Balancing for DOCSIS 3.0

To enable DOCSIS load balancing, run the following commands:
Router# config terminal
Router(config)# cable load-balance docsis-enable
Router(config)# end
When DOCSIS load balancing is enabled, run the following commands to enable load balancing for DOCSIS
3.0.
Router# config terminal
Router(config)# cable load-balance docsis30-enable
Router(config)# end

Enable DOCSIS 3.0 Static Load Balance

To balance the load of primary channels, enable static load balance using the following commands:
Router# configure terminal
BG Size Create Time
Sep 14 14:40:27 MODEM_ONLINE
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Configure Load Balancing with Dynamic Bonding Group Enabled
Create Client Reclaim Time
Sep 14 14:44:27 DBG_INTERNAL
Reclaim Client RFid
73