Prerequisites For Rpd Operations; How To Access And Debug Rpd; Debugging Rpd - Cisco Remote PHY Shelf 7200 Software Configuration Manual And Command Reference

Prerequisites for RPD Operations

Prerequisites for RPD Operations
The following prerequisites are applicable for debugging or checking RPD operations:
• RPD has established GCP connection with the CCAP-core, and RPD IP address is retrievable from
• RPD is assigned an IP address through the DHCP process, and the IP address is retrievable from the

How to Access and Debug RPD

Note To know more about the commands referenced in this module, see the
To access RPD, log into RPD using your username and password.

Debugging RPD

Use the following procedure to debug RPD:
1. Disable RPD auto reboot by setting the reboot hold.
R-PHY# set reboot hold
2. Collect the show CLI output.
For RPD online issues, check which status is failed. You can check the following outputs:
For modem online issue, check ds/us config and l2tp session.
You can collect the following outputs:
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
102
Cisco Remote PHY Shelf 7200 Management Guide for Cisco Remote PHY Shelf 7200 Software 1.x
CCAP-core.
DHCP server.
• show provision all
• show provision history
• show dhcp
• show tod
• show ptp clock 0 config
• show ptp clock 0 state
• show downstream channel configuration
• show downstream channel counter dps (show multiple times)
• show downstream depi configuration
• show upstream channel configuration <port number> <channel number>
• show upstream iuc counter <port number> <channel number> (show multiple times)
Cisco IOS Master Command List.