Table of Contents
Advertisement
PIC
PIC
The PIC card uses solid-state switch to create a switching path between the dedicated protect RPD in slot 6
and the 12 other RPDs in the Cisco Remote PHY Shelf 7200 chassis. The features of the Cisco Remote PHY
Shelf 7200 PIC are:
• Surge protector
• Demodulator
• Power meter
• US test signal
• Solid-state switches 2:1, 6:1
• DS RF amp for better return loss matching
• MES in control of all PIC functions through I2C control
• Simplified power design and power sequencer
• DS at MCX connector meets the DOCSIS 3.1 RF specification
• ACT2 PID
• FLASH holding calibration data
• No firmware upgradeable images
• US and DS ports accept 75 Ohm accepts compression type MCX connectors
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
6
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote PHY Shelf 7200 and is the answer not in the manual?