Associate R-Dti With Rpd; Verifying Associating R-Dti With Rpd - Cisco Remote PHY Shelf 7200 Software Configuration Manual And Command Reference

Associate R-DTI with RPD

Port local Address :40.3.6.193
Unicast
Announce
Delay-Req Intreval : -4 Pdelay-req
Priority
==Stream 8 : Port 22 Master IP: 10.10.1.11
Router# show ptp clock 6 config
Domain/Mode
Priority 1/2/local
Profile
Total Ports/Streams : 1
--PTP Port
Port local Address :40.3.6.194
Unicast
Announce
Delay-Req Intreval : -4 Pdelay-req
Priority
==Stream 10: Port 22 Master IP: 10.10.1.11
Associate R-DTI with RPD
To associate the RPD with R-DTI, use the following commands..
enable
configure terminal
interface type [slot_#/]port_#
cable rpd node1
identifier badb.ad17.4820 (node vbh0 mac)
core-interface Te7/1/4
rpd-ds 0 downstream-cable 7/0/16 profile 0
rpd-us 0 upstream-cable 7/0/16 profile 0
r-dti 20
rpd-event profile 0

Verifying Associating R-DTI with RPD

The following example shows how to verify whether the RPD is associated to R-DTI:
Router# show running-config | sec r-dti
r-dti 20
r-dti 20
r-dti 20
r-dti 20
r-dti 20
r-dti 20
ptp r-dti 20
profile G.8275.2
ptp-domain 55
clock-port 22
ethernet 1
clock source ip 10.10.1.11
Router# show running-config | sec cable rpd
cable rpd nh13-00
identifier badb.ad17.4820
core-interface Te7/1/4
principal
rpd-ds 0 downstream-cable 7/0/16 profile 0
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
20
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Duration :300 Sync Interval : -4
Interval : 0 Timeout
local :128 COS: 6
: 55/OC_SLAVE
: 128/255/128
: 001b19000100-000000 E2E
/1
22, Enet Port 1 ----
Duration :300 Sync Interval : -4
Interval : 0 Timeout
local :128 COS: 6
: 11
: -4
DSCP: 47
: 11
: -4
DSCP: 47