Configuring Cbr-8 - Cisco Remote PHY Shelf 7200 Software Configuration Manual And Command Reference

Configuring cBR-8

clock-port Master-to-all-cBR8 master
sync interval -5
sync one-step
transport ipv4 unicast interface Lo1588 negotiation
interface Loopback1588
ip address 10.90.3.93 255.255.255.255
interface GigabitEthernet0/3/5
no ip address
negotiation auto
cdp enable
service instance 31 ethernet
encapsulation dot1q 31
rewrite ingress tag pop 1 symmetric
bridge-domain 31
service instance 32 ethernet
encapsulation dot1q 32
rewrite ingress tag pop 1 symmetric
bridge-domain 32
interface BDI31
ip address 192.104.10.93 255.255.255.0
no shut
interface BDI32
ip address 93.3.10.2 255.255.255.0
no shut
ip route 159.159.159.4 255.255.255.255 192.104.10.48
Configuring cBR-8
To configure the cBR-8 to bring up the RPD, use the following example as reference:
/* D-PIC TenGiga interface config */
interface TenGigabitEthernet0/1/0
ip address 93.3.10.1 255.255.255.0
ip helper-address 20.1.0.33
/* Downstream/Upstream controller profile */
cable downstream controller-profile 1
rf-chan 0 95
type DOCSIS
frequency 381000000
rf-output NORMAL
qam-profile 1
docsis-channel-id 1
cable upstream controller-profile 2
us-channel 0 channel-width 6400000 6400000
us-channel 0 docsis-mode atdma
us-channel 0 minislot-size 4
us-channel 0 modulation-profile 221
no us-channel 1 shutdown
/* RPD configuration */
cable rpd node1
identifier 0004.9f03.0061
type shelf
core-interface Te0/1/0
rpd-ds 0 downstream-cable 7/0/0 profile 1
rpd-us 0 upstream-cable 7/0/0 profile 2
rpd-us 1 upstream-cable 7/0/8 profile 2
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
12
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
/* 31 is vlan id */
/* for cBR, SUP PIC */
/* For RPD */
/* route to cbr-8 loopback ip */