If You Are Re-Using The Samp/Dual Nic - Avaya S8510 Manual

Job Aid: Replacing the Avaya S8510 server
4. Release the rail lock by pushing the level in as you slide the server out of the rack (Note 3 in
Figure 2).

If you are re-using the SAMP/dual NIC

If you are re-using the SAMP and/or the dual NIC from the defective server, complete this
section. Otherwise, omit this section and continue with
the rack on page 20.
Remove the cover of the S8510 server
!
CAUTION:
Ensure that the power is completely removed from the server: power cords must
CAUTION:
be detached from the power supply(ies) and the SAMP.
To remove the cover from the S8510 server to access internal components:
1. Use a #2 Phillips (cross-point) screwdriver to rotate the latch release lock counter-clockwise
to the unlocked position (Note 1 in
14 Job Aids for Field Replacements (FRUs) for the Avaya S8510 Server
Install the replacement S8510 server in
Figure 3).