Install The Software - Avaya S8510 Manual

Install the software

To install the software on the S8510 server:
1. Connect your laptop to the server using the crossover cable.
2. At your laptop click on Start > Run to open the Run dialog box.
3. Type telnet 192.11.13.6 and press Enter.
4. The installation script looks for the customer's Communication Manager (software) CD in
the server's optical drive. If the CD is not present when the server booted up, you will not
see any activity on the screen. In this case perform the following:
a. Press the power button on the front panel (Note 1 in
Continue only after the server has powered down and the power-on indicator light is out.
b. Place the customer's Communication Manager (software) CD in the optical drive and
close the door.
c. Press the power button on the front panel.
d. Wait for the server to reboot.
The installation utility displays.
Tip:
To navigate the installation screens, use the arrow keys to move to an option,
Tip:
then press the space bar to select the option. Press Enter to submit the screen.
5. Select Install and press Enter.
The Select Release Version screen displays.
6. Select the appropriate release version then select OK and press Enter.
The following processes are initiated:
- The server's hard drive and internal Compact Flash are partitioned and reformatted.
- The Linux operating system is installed.
- Once the drive is properly configured, Communication Manager software is installed and
the progress reported.
The process takes about 30 minutes. When the server is ready to reboot, the CD drive door
opens and a reminder to check the Avaya Support Site (support.avaya.com/downloads) for
the latest software and firmware updates displays.
The reboot takes 1-3 minutes.
7. At your laptop click Start > Run to open the Run dialog box.
8. Type ping -t 192.11.13.6 and press Enter.
9. Wait for the reply from the server to ensure connectivity to it.
Install Communication Manager
Figure 1).
03-602953 Issue 1 June 2008 21