Table of Contents
Advertisement
Job Aid: Replacing the Avaya S8510 dual network interface
Replacing the dual NIC in the S8510 server
The components of this procedure include:
Record Ethernet interface settings
•
Back up data
•
Power down the server
•
Label and disconnect cabling
•
Remove the S8510 server from the rack
•
Remove the cover of the S8510 server
•
Remove the defective dual NIC from the S8510 server
•
Install the replacement dual NIC in the S8510 server
•
Replace the cover on the S8510
•
Install the replacement S8510 server in the rack
•
Check LED activity on the dual network interface card
•
Configure the dual NIC
•
Test connectivity to the network
•
Return the defective equipment
•
Record Ethernet interface settings
Before replacing the dual network interface, write down the Ethernet interface settings:
1. Go to Server Configuration > Configure Server Web page.
2. Click Continue through the review notices until you get to the Configure Server page with
"Specify how you want to use this wizard" at the top.
3. Select Configure Individual Services and click Continue.
The wizard displays a new left-side navigation panel.
4. Select Set Identities.
The Set Server Identities page displays.
5. Write down the Ethernet interface settings. You will use them again at
NIC
on page 54.
44 Job Aids for Field Replacements (FRUs) for the Avaya S8510 Server
Configure the dual
Advertisement
Table of Contents
