Adjusting The Opening Of The Door; Initial Commissioning - Hanseatic WQP8-J7710E User Manual

Page EN-26 Installation and assembly
Adjusting the opening of the
door
You can adjust how easy or difficult it is to
open the dishwasher door.
– Turn the screw counter-clockwise to make
the door open more smoothly.
– Turn the screws clockwise to make it hard-
er to open the door.

Initial commissioning

Carry out a test run before using the dish-
washer for the first time. This removes pro-
duction residues and excess dishwasher salt
and you can test the proper functioning of the
dishwasher. Carry out the test run without
dishwasher detergent and dishes.
1. Open the tap completely.
2. Close the dishwasher door.
(1)
3. Switch on the dishwasher with button (1)
. An audible alarm will sound and the
display (6) will light up. The ECO pro-
gramme is selected.
4. With button (8) P, select the 60 minutes
programme.
5. Start the programme: Press button (9)
. The programme begins after a few sec-
onds. The display shows the remaining
running time of the current programme.
6. Pay attention to water leakages and unu-
sual noises.
7. An audible alarm will sound after the end
of the programme. Switch off the dish-
washer with button (1)
8. Slightly open the door to allow the moist
air to escape.
9. Turn off the tap.
The test run is now complete.
If no water has escaped and no unusual nois-
es have occurred, the dishwasher is ready for
operation and you can add the detergent and
put dishes into the dishwasher (see „Clean-
ers" on page EN-10) and (see „Loading the
dishwasher" on page EN-13).
(8) (9)
.