Hanseatic WQP8-J7710E User Manual page 56

Page EN-24 Installation and assembly
dishwasher so that you can later screw
the dishwasher to the worktop.
3. Remove the protective films from the
end profiles (27).
4. Affix the end profiles (27) to the left and
right edge of the dishwasher to cover the
gap between the dishwasher and the ad-
joining kitchen cupboards.
5. Push the dishwasher into the nook.
6. To enable the dishwasher to be posi-
tioned in a level position, both the front
and back appliance feet can be adjusted
by up to 50 mm.
The front feet are equipped with slots.
Insert a screwdriver into one of the slots
and turn the appliance's feet to the de-
sired height.
(27) 7. Adjust the height of the rear appliance
foot using the middle adjustment screw.
Use a star-headed screwdriver for this
purpose.
8. Check the horizontal alignment using a
level.
9. Make sure the top edge of the dish-
washer is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the door.
Screw the dishwasher to the kitchen
units
(31)
a) For granite worktops, remove the internal
cover caps (32) and screw the dishwasher
to the side kitchen cupboards.
Cover the screws again with the cover
caps.
b) For all other worktops, screw the mounting
bracket (31) to the work surface until it is
fixed.
b
a
(32)