Programmes And Additional Options; Switching On The Dishwasher; Programme Selection Button; Half Load - Hanseatic WQP8-J7710E User Manual

Page EN-16

Programmes and additional options

Programmes and additional options

Switching on the dishwasher

1. Open the tap completely.
2. Close the dishwasher door.
(1) (6)
3. Switch on the dishwasher with button (1)
. An audible alarm will sound and the
display (6) will light up. The ECO pro-
gramme is selected.

Programme selection button

You can choose between 7 programmes, de-
pending on the type or quantity of dishes or
degree of soiling.
1. Select the correct cycle using the 'Pro-
gramme table' (see „Programme table" on
page EN-19).
2. Press button (8) P for so long until the
LED lights up in front of the desired pro-
gramme(7).
The programme is selected.

Half load

If you only load the upper basket (21) or only
the lower basket (23), you can deactivate the
unused spraying arm (15) or (22).
(13) (12)
• Activate or deactivate the spraying

Delaying the start time

If you do not want the selected programme
to start immediately, you can set the desired
time until start (one hour to 24 hours).
• Set the start time delay using the buttons
(7) (8)

Starting the programme

• Press button (9)
(10)
arm (15) or (22) by pressing button (10)
/ .
If a spraying arm is activated, the LED
behind the spraying arm symbol (12)
and/or (13) lights up.
(2) (6)
(2) and :
– Press button (2) to increase the start
time delay beginning with an hour.
– Press button (2) to decrease the start
time delay beginning with 24 hours.
The selected value appears on the display
(6):
– K: 0 0 = no start time delay
– K: 2 4 = start time delay of 24 hours
(6)
.
If you have not set a start time delay,
the programme starts after a short time.
You will hear the water entering and the
display (6) shows the remaining running
time.
If you have set a start time delay, the cy-
cle does not start automatically until this
time has elapsed.
(9)