Mounting The Front Panel; Adjusting The Opening Of The Door - Hanseatic 429300 User Manual

a) If you have granite worktops, re-
move the internal side cover caps (e)
and screw the dishwasher to the ad-
jacent kitchen cupboards.
Re-cover the screws (k) with the cover
caps.
b) For all other worktops, screw the
mounting bracket (f) to the work sur-
face until it is fixed.

Mounting the front panel

You can mount a stainless steel front panel
on the dishwasher door, or another front pan-
el design which matches your kitchen. The
front panel must not exceed a weight of 5 kg.
1. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
2. Transfer the drill holes from the drill tem-
plate to the front panel.
3. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
(h) (g) (l)
4. Affix both installation hooks (h) with four
screws (l) each onto the front panel.
5. Affix both mounting pegs (g) using the
screws (j) onto the front panel.
Installation, connection and initial commissioning
6. Hang the front panel on the door of the
(i)
(j)
(g)
7. Remove the 4 screws from the inside of
(h)
The front panel is then mounted.
Adjusting the opening of the
door
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
dishwasher, hold it in place and open the
door carefully.
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (i).
Page EN-27
(i)