Deleting A Component; Connecting Component With Multiple Devices; Use; Movement Patterns In Basic Mode (Mode 1) - Otto Bock Genium X3 3B5-2 Instructions For Use Manual

Use

→ Once the connection has been established, the data are read from the component. This process may take
up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component")
► Add the component again in the Cockpit app (see the section "Adding a component")

9.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the symbol under the component you want to delete.
→ The component is deleted.

9.4.3 Connecting component with multiple devices

The connection for a component can be stored on more than one device. However, only one device or remote con­
trol can be connected to the component at one time.
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
10 Use

10.1 Movement patterns in basic mode (mode 1)

10.1.1 Standing

Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled using the adjustment software. Please see the following
section for further information on the stance function.

10.1.1.1 Stance function

INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activated using the Cock­
pit app or remote control (see Page 35).
The stance function (standing mode) is a functional supplement to the basic mode (mode 1). This function makes it
easier, for example, to stand on an inclined surface for a longer time. The joint is fixed in the flexion direction.
This function must be enabled in the adjustment software. Once the function is enabled, you can also choose
between an intuitive and a conscious lock.
30
► Tap the OK button.
→ The connection to the last connected device is broken off and estab­
lished with the current device.
OK
Genium X3 3B5-2/3B5-2=ST