Scope Of Delivery And Accessories - Otto Bock Genium X3 3B5-2 Instructions For Use Manual

Scope of Delivery and Accessories

CAUTION
Independently applied changes or modifications made to the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
► Do not make any independent changes to the hardware of the device.
► Do not make any independent changes to the software/firmware of the device which are not included in the
update function of the software/firmware.
CAUTION
Improper mode switching with the device
Falling due to unexpected product behaviour because of changed damping behaviour.
► Ensure that the patient stands securely during all switching processes.
► Inform the patient that the changed damping characteristics have to be verified after switching, and feedback
from the acoustic signal emitter and the device display must be observed.
► Switching back to basic mode is mandatory once the activities in MyMode have been completed.
NOTICE
Destruction of the device due to falling or penetration of water
Malfunction of the device.
► If necessary, let the device dry at room temperature (at least 1 day).
► If it should no longer be possible to switch back from a MyMode to basic mode, the component can only be
switched back to basic mode by using a movement pattern (see Page 42) or by connecting/disconnecting the
inductive battery charger.
NOTICE
Failure to observe the system requirements for the installation of the cockpit app
Malfunction of the device.
► Install the cockpit app only on the operating systems listed in the section "System requirements" (see
Page 27). The tested devices are listed in this section as well.
6 Scope of Delivery and Accessories
Scope of Delivery
• 1 pc. 3B5-2=ST Genium X3 (with threaded con­
nector) or
1 pc. 3B5-2 Genium X3 (with pyramid connector)
with preinstalled 4X900 or 4X193-1 Genium X3 Pro­
tective Cover
• 1 pc. 2R19 AXON tube adapter
• 1 pc. 757L16* power supply
• 2 pc. M5x16 Torx screws (as replacement for the installed screws of the tube clamp)
• 1 pc. cosmetic case for battery charger and power
supply
• 1 pc. 647F542 prosthesis passport
• 1 pc. card holder for prosthesis passport
• 1 pc. 647G1149 instructions for use (qualified per­
sonnel)
Accessories
The following components are not included in the scope of delivery and may be ordered separately:
• Genium X3 Protective Cover: 4X900
• Genium X3 Protective Cover: 4X193-1
• X3 – flexion stop 22.5°: 4H104
20
• 1 pc. 4E60* inductive charger
• 1 pc. 4H101 7.5° X3 flexion stop
• 1 pc. 4H102 15° X3 flexion stop (preassembled on
delivery)
• 2 pc. M3x5 Torx screws (as replacement for the
installed screws of the flexion stop)
• 1 pc. T10 Torx bit
• 1 pc. 646C107 Bluetooth PIN card
• 1 pc. 646D460, 646D460=1 instructions for use
(user)
• Android app "Cockpit 4X441-Andr=V*" for down­
load from
http://www.ottobock.com/cockpitapp
• 4X350-X3 remote control
The user interface is available in the following lan­
guages: German, English, French, Italian, Spanish,
Dutch, Swedish
the website:
Genium X3 3B5-2/3B5-2=ST