Otto Bock Genium X3 3B5-2 Instructions For Use Manual page 50

Appendices
Beep signal
10x long
30x long
Error while charging the product
LED on Status LED
power sup­ on battery
ply charger
Status LED Charging status indicat­
The LED
ring is lit in
weak purple
The LED
ring is lit up
yellow
50
Vibration signal
10x long
1x long, 1x short repeated
every 3 seconds
Error
Country-specific plug adapter not fully
engaged on power supply
Non-functional socket
Defective power supply
No connection between battery charger
and power supply
Defective battery charger
or (5 LEDs)
No LED is lit
LED 2 and 4 are lit up
LED 1, 3 and 5 are lit up
LED 3 is lit up
Event
Battery charge level 5%
After the beep and vibra­
tion signals, the product
switches to empty battery
mode and then switches
off.
Severe error
e.g. failure of valve drives
Possibly no switching into
safety mode (see
Page 43).
Resolution
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Check socket with another electric appli­
ance.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Check whether the charging cable plug is
fully engaged on the battery charger.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Error
Distance between battery
charger and receiver of the
charging unit on the pros­
thesis too great. If the dis­
tance is more than 2 mm,
the prosthesis cannot be
charged.
Charger excess temperat­
ure
Excessively high or low
temperature of the pros­
thesis
The prosthesis is not being
charged
Distance between battery
charger and receiver of the
charging unit too great.
Required action
Charge the battery.
Restricted walking possible.
Please note the possible
change in flexion/extension
resistance.
Attempt to reset this error by
connecting/disconnecting the
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Center.
Resolution
Reduce distance between
battery charger and receiver
of the charging unit.
Check whether the spe­
cified ambient conditions for
charging the battery are met
(see Page 46).
Connection may
improved by reducing the
distance between the char­
ger and receiver of the char­
ging unit.
Genium X3 3B5-2/3B5-2=ST
be