Maintenance; Identification Of The Product By The Service Center; Legal Information; Liability - Otto Bock Genium X3 3B5-2 Instructions For Use Manual

Maintenance

INFORMATION
Please note that the weight of dirt adhering to the prosthesis can affect the gait pattern.
15 Maintenance
INFORMATION
This component was tested for three million load cycles in accordance with ISO 10328.
Depending on the activity level, this corresponds to a service life of three to five years.
The duration of use can be individually extended depending on the intensity of use by performing regular service
inspections.
Regular service inspections are recommended in the interest of the patient's safety and in order to maintain operat­
ing reliability and protect the warranty. These service inspections include an inspection of sensors and replacement
of worn parts.
To have a service inspection carried out, please send the product with mounted tube adapter as well as the battery
charger and power supply unit to an authorised Ottobock Service Centre.
INFORMATION
Before shipping the knee joint, the top of the knee joint should be angled to avoid air getting into the hydraulic
system during transportation.
INFORMATION
If a remote control was included in the scope of delivery as an optional product accessory, it must also be sent
along with the product for service inspections.

15.1 Identification of the product by the Service Center

The product may have been identified by an authorised Ottobock Service Center:
Factory setting
The patient-specific product settings have been reset to the state at delivery (factory setting).
User setting
The settings already configured using the adjustment software were not changed.
CAUTION
Use of the prosthesis with incorrect setting data
Falling due to unexpected prosthesis behaviour caused by triggering the swing phase at the wrong time.
► The prosthesis settings (parameters) have to be checked using the corresponding adjustment software and
changed as needed.

16 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.

16.1 Liability

The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of the product.

16.2 Trademarks

All product names mentioned in this document are subject without restriction to the respective applicable trade­
mark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of the respective
owners.
44 Genium X3 3B5-2/3B5-2=ST