Display Of The Current Charge Level; Display Of Battery Charge Level Without Additional Devices; Display Of The Current Charge Level Using The Cockpit App; Display Of Current Charge Level Using Remote Control (Optional Accessory) - Otto Bock Genium X3 3B5-2 Instructions For Use Manual

Charging the battery

7.3 Display of the current charge level

7.3.1 Display of battery charge level without additional devices

INFORMATION
The charge level cannot be displayed by turning the prosthesis over during the charging process.
Beep signal
5x short
4x short
3x short
2x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control (see Page 34) or if mute
mode (silent mode) is activated, there are no beep signals.

7.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:

7.3.3 Display of current charge level using remote control (optional accessory)

The current charge level is displayed in the status bar of the remote control when it is connected and switched on:

7.3.4 Display of the current charge level during the charging process

During the charging process, the current battery charge level is indicated by the LEDs lit on the side of the char­
ger.
22
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beep signals.
1. 38% – Charge level of battery for currently connected component
1. – Charge level of battery for currently connected prosthesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected prosthesis, as a
percentage
Battery charge level
more than 80%
60% to 80%
40% to 60%
20% to 40%
less than 20%
Quantity
0
1
2
3
4
5
Battery charge level
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
Genium X3 3B5-2/3B5-2=ST