Back - Gefen EXT-4K600A-MF-51-HBTLS User Manual

4k ultra hd 600 mhz multi-format 5x1 scaler w/ auto-switching & split hdmi & hdbaset outputs
Table of Contents

Advertisement

Back

5
6
13
14
ID
Name
10
Audio Out
11
Audio In 1~5
Bal In Port
12
Mic/Line
Switch
HDBaseT™
13
Out
14
HDMI Out
15
HDMI In (1-3)
DisplayPort™
16
In (4)
17
VGA In (5)
Firmware
18
Port
19
12V DC
7
8
9
10
15
Description
Connect an amplifier to one of the included removable 3-pin
"Captive Screw" Phoenix plugs and attach to the unbalanced stereo
audio out port. Make sure to follow channel and polarity markings.
The audio on this port will correspond to the selected video source
and is mixed with Mic audio.
Connect unbalanced stereo audio sources to the included
removable 3-pin "Captive Screw" Phoenix connectors plugs,
observing channel and polarity markings, and attach them to one of
the 5 audio input ports. Each audio input is assignable.
Connect either a balanced or unbalanced condenser/dynamic
microphone, or other single-channel audio source to one of the
included 3-pin "Captive Screw" Phoenix plugs and attach to this
connector, observing polarity markings. The Mic/Line mode and
48V Phantom Power is set via this switch.
Connect a CAT-5e or better cable, shielded CAT-6A preferred, up to
the recommended length for a given resolution, from this port to the
HDBaseT™ In port on the optional Receiver unit.
Connect a Gefen Locking HDMI cable from this port to an HDMI
capable display. The HDMI output includes internal HDMI audio or
external audio from any of the audio inputs.
Connect a Gefen Locking HDMI cable from an HDMI source to
each of these ports. A DVI source can be connected using an
adapter.
Connect a DisplayPort 1.2 cable from a DisplayPort source to
this port.
Connect a VGA cable from a VGA source (e.g. computer) to this
port. Component (YPbPr) and Composite (CVBS) video can also
be connected using an adapter cable.
To update the system firmware, connect a USB thumb drive that
contains the firmware file to this USB Type-A port. Firmware
update requires the use of Gefen Syner-G™ software.
Connect the included 12V DC power supply to this power
connector.
page | 3
Panel Layout
11
16
17
18
12
19

Advertisement

Table of Contents
loading

Table of Contents