Installation And Basic Operation; Sample Wiring Diagram - Gefen EXT-4K600A-MF-51-HBTLS User Manual

3. To use de-embedded audio from the HDMI output with an outboard audio amplifier, wire
the Audio Out of the 5x1 Scaler to your amplifier.
4. To use the built-in Web Server, Telnet or UDP to control the scaler, connect an Ethernet
cable from your Local Area Network (LAN) to the IP Control port. Use the
Syner-G™ software
192.168.1.72, and the password is 'admin' for the Administrator account.
5. To provide power to the Scaler and the HDBaseT™ Receiver (through the link cable),
connect the Scaler's power supply to its 12V DC jack and to an available electrical
outlet. The Receiver can also be powered locally, but it cannot power the Scaler.
6. The IR remote can be used at the Scaler side or remotely at the Receiver end. It
provides access to Main Volume and Microphone Level controls and the intuitive On
Screen Display (OSD).

Sample Wiring Diagram

Powered Speakers
RS-232
or Audio Amplifier
Device-To-Be-
w/analog L/R input
Controlled *
IR Emitter
to Remote
Display
Remote
Display

Installation and Basic Operation

to discover and configure IP settings. The default IP address is
IR Extender
RS-232 Third-Party
(EXT-RMT-EXTIRN)
Controller for
for 5x1 Switcher
5x1 Switcher control
and remote display
and Extension
IR Emitter
Audio Amplifier
LAN
w/ coaxial digital
input
EXT-UHDA-HBTL-RX
Receiver (Back)
Audio Amplifier
w/ optical digital input
Local
Display
page | 5
Powered Speakers
or Audio Amplifier
w/analog L/R input
control
5x
Audio Source
to
with Analog
Source(s)
L/R outputs
5x
Momentary
Contact
Push-Buttons
(1 shown)
EXT-4K600A-MF-51-HBTLS
3x
4K Ultra HD
HDMI Source
4K DisplayPort™ 1.2 Source
Gefen
CAT-5e CABLE
HDMI CABLE
DISPLAYPORT™CABLE
VGA CABLE
RS-232 CABLE
ANALOG AUDIO CABLE
OPTICAL DIGITAL AUDIO
COAXIAL DIGITAL AUDIO
IR IN
IR OUT
LOW VOLTAGE WIRE
Microphone
5x1 Switcher (Back)
VGA Source
EXT-4K600A-MF-51-HBTLS
EXT-UHDA-HBTL-RX