Table of Contents
Advertisement
Using Telnet
1. Launch the desired terminal application. For example, on the Windows operating
system, we can use Hyperterminal; on Mac OS X, we can use the Terminal
application.
2. In this example, we will use Terminal in Mac OS X. At the command prompt, type the
following:
telnet IP_address
IP_address
where
3. After correct settings have been used in the terminal program, information similar to the
following will be displayed:
********Welcome to the EXT-4K600A-MF-51-HBTLS********
***************************************************
>
#help
4. Type
for a list of commands or refer to the tables on the following pages.
Using RS-232
1. Launch the desired terminal application.
2. Selected the assigned COM port.
3. Configure the RS-232 port to the following settings.
Description
Baud rate
Data bits
Parity
Stop bits
Hardware flow control
4. Connect to the RS-232 port (DB-9 connector). Only TxD, RxD, and GND pins are used.
#help
5. Type
for a list of commands or refer to the tables on the following pages.
NOTE: Depending upon the network, all related IP and Telnet
i
i
settings will need to be assigned. Consult your network administrator
to obtain the proper settings.
It is highly recommended that you disable ECHO when controlling a
serial (RS-232) device from a remote receiver. This setting can be
changed with the command #SET_ECHO
or IP Control interface.
RS-232 and IP Configuration
is the IP address of the 4x1 Multiview Seamless Switcher.
Firmware Version: v3.66
Setting
19200 (default)
8
None
1
None
page | 41
(pg.
50) using the RS-232
Advertisement
Table of Contents
