Powering the Multi-Format Scaler
1. Make sure the included 12V DC power supply is connected from the Multi-Format
Scaler to an available electrical outlet.
2. Press and release the Power button on the front panel.
3. The power button will illuminate blue.
Power On
4K Ultra HD Multi-Format 5x1 Scaler w/ Auto-Switching & HDBaseT™ Output
NOTE: The Multi-Format Scaler can also be turned on and off with
i
i
the IR Remote Control, the Web Interface, or by an external controller
using either RS-232 or IP Telnet control.
Selecting a Video Input
The Multi-Format Scaler allows you to switch between five simultaneous connections. By
default, AUTO is active, as well as the auto-detected Input.
Press the button corresponding to your desired Input. The selected button will illuminate
blue.
Select from the following inputs: AUTO, HDMI (1-2-3), DisplayPort and VGA.
4K Ultra HD Multi-Format 5x1 Scaler w/ Auto-Switching & HDBaseT™ Output
NOTE: The Video Input Selection can also be changed with the IR
i
i
Remote Control, the Web Interface, or by an external controller using
either RS-232 or IP Telnet control, or via the Contact Closure Inputs
on the back panel.
Selecting an Audio Input
Audio inputs must be selected and/or paired with video inputs using the built-in Web
interface or On Screen Display (OSD). See Setup ► Audio
Power
IR
Auto
HDMI
Auto On
HDMI 1 Detected
Power
IR
Auto
HDMI
page | 13
Front Panel Controls
2
3
4
1
HDMI
DisplayPort™
HDMI
2
3
4
1
HDMI
DisplayPort™
HDMI
(page
EXT-4K600A-MF-51-HBTLS
5
VGA
EXT-4K600A-MF-51-HBTLS
5
VGA
31) for more information.