Perspective View - Standard Horizon CPV550 Owner's Manual

4. Move the ShuttlePoint knob to select the selection and press [ENT].
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
NORMAL size
Figure 4.0.1 - Example of Normal size (on the left side) and Large side (on the right side) settings
4.0.2

Perspective View

Chart data may be projected in perspective mode during navigation. This function allows
setting the panoramic View of the chart. As the upper side of the map is more compressed
than the lower side, a wider map area is visible. The perspective view allows showing more
chart information immediately ahead and around the cursor.
To activate this function follow the procedure:
1. From the chart page, press [MENU] twice. Move the ShuttlePoint knob to highlight MAX
FUNCTIONS and press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight PERSPECTIVE VIEW and press [ENT] or
move the ShuttlePoint knob to the right.
3. The menu now shows two selections, ON or OFF.
4. Move the ShuttlePoint knob to select the selection and press [ENT].
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the chart page is shown.
Page 30
LARGE size
Figure 4.0.2 - Perspective View
CPV550