Changing Gps Information To Vessel Position Or Cog; External Speaker Af Selection - Standard Horizon CPV550 Owner's Manual

22.4.1 Changing GPS Information to Vessel position or COG

Allows customizing the NAV data showing GPS Information. Factory default is "Your
Vessel's Current Position," however, following the steps below the GPS Information can be
changed to "Course Over Ground (COG)."
1. Press and hold down the [CALL(MENU)] key until "RADIO SETUP"
menu appears.
2. Press the [ENT] key, then select "NAV DISPLAY" with the [ ]/[ ] key.
3. Press the [CALL(SET)MENU] key.
4. Press the [ ] or [ ] key to select "Pos (Your Vessel's Current Position)"
or "Cru (Course Over Ground)."
5. Press the [ENT] key to store the data entered, then press the [16/9] key
to exit this menu and return to radio operation mode.

22.4.2 External Speaker AF Selection

The AF SELECT menu allows you to set the audio output level of the VH-310's External
Speaker to "fixed" regardress the VOL level setting of the VH-310, which is useful to the case
when use with the amplified speaker, such as the Standard Horizon MLS-310.
1. Press and hold down the [CALL(MENU)] key until "Radio Setup" menu
appears.
2. Press the [ENT] key, then select "AF SELECT" with the [ ]/[ ] key.
3. Press the [ENT] key.
4. Press the [ ] or [ ] key to select "Pr" (External Speaker Level is "Fixed")
or "Po" (External Speaker Level is "Adjustable").
5. Press the [ENT] key to store the data entered, then press the [16/9] key
to exit this menu and return to radio operation mode.
CPV550 Page 129