2.6.0
Output Sentences
GLL, VTG, BWC, WCV, APA, APB, HDG, BOD, XTE, RMA, RMB, RMC, GGA, HSC, DBT,
DPT, MTW, VWH, MWV
2.6.1
Input Sentences
VHF Radio - DSC, DSC
Radar - TLL
AIS Receiver - VDM
2.6.2
Cables
The CPV550 is supplied with two accessory cables used with AUX 1 and I/O connectors on
the rear panel. Below is the pin out and connection examples of the cables.
2.6.3
I/O Connector Table
Pin
Wire Color
Description
1
Black
-- -
2
Red
-- -
3
Green
NMEA Common
4
Blue
NMEA Input Port 1
5
Brown
NMEA Output Port 1
6
Gray
NMEA Input Port 2
7
White
NMEA Output Port 2
8
Yellow
NMEA Output Port 3
2.6.4
AIS Receiver Setup
Connect the NMEA output and NMEA common wires of the AIS receiver to the Port 1 (blue
and Green wires. For the Chart Plotter to show AIS targets the NMEA in/out Connections
menu must be changed to AIS 38400 as shown below.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP
MENU and press the [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press the [ENT] key.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press the [ENT]
key.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press the [ENT] key.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press the [ENT] key.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
CPV550
Connection Example
No Connection
No Connection
Common for NMEA devices
Conncect to output of NMEA device
Conncect to intput of NMEA device
Conncect to output of NMEA device
Conncect to intput of NMEA device
Connect autopilot
Additional Information
Default is NMEA0183
Default is NMEA0183 with GLL. RMB, RMC, and XTE sentences
Default is NMEA0183
Default is NMEA0183 with GLL. RMB, RMC, and XTE sentences
Default is NMEA0183 with APA. APB, XTE, COG, and BOD sentences
Page 21