Priority Channel Set - Standard Horizon CPV550 Owner's Manual

5. To start priority scanning, press [SCAN/MEM] momentarily. "P-
SCAN" appears in the "VHF Radio" window on the display. Scanning
will proceed between the memorized channels and the priority
channel. The priority channel will be scanned after each programmed
channel.
6. To stop scanning, press [16/9] or [WX].

18.11.3 Priority Channel Set

1. Select the chart page and press the [MENU] key two times. Move the ShuttlePoint knob
to highlight RADIO SETUP and press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight VHF SETTINGS and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PRIORITY CHANNEL SET and press [ENT]
or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to select USA, INTL, or CAN, and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to select the channel to be a priority.
6. Press [ENT] to store the selected setting.
7. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
Page 92
Figure 18.11.3 - PRIORITY CH menu
CPV550