Device Manager; Maintenance - SolarEdge SE66.6KUS Installation Manual

The Energy Manager o ption is used for setting power export limitation,
as described in the Export Limitation Application Note, available on the
SolarEdge website at
https://www.solaredge.com/sites/default/files/feed-in_limitation_
application_
note.pdfhttps://www.solaredge.com/sites/default/files/export_
limitation_application_note_NA.pdf.
For P(Q) diagram refer to https://www.solaredge.com/sites/default/files/application_
note_p_q_diagram_of_se_inverters_en_and_na.pdf.
NOTE
SolarEdge inverters with "Grid Support" functionality (as marked on the inverter certification label), are
compliant with UL 1741 Supplement A. The functionality is built into the inverter and no additional
external device is required.

Device Manager

From the Commissioning menu, select Device Manager to configure various system Smart Energy
Management devices.
For more information refer to https://www.solaredge.com/products/device-control#/.

Maintenance

From the Commissioning menu, select Maintenance to configure various system
settings, as described below.
Date and Time: Set the internal real-time clock. If connected to the m onitoring platform, the date
l
and time are set automatically and only time zone should be set.
Reset Counters: Resets the accumulated energy counters that are sent to the m onitoring platform
l
Factory Reset: Performs a general reset to the d efault device settings.
l
Arc Fault Circuit Interrupter (AFCI): Enables or disables production interruption in case of arc-fault,
l
sets the reconnection mode, and enables or disables manual AFCI self-test.
Refer to http://www.solaredge.com/sites/default/files/arc_fault_detection_
application_note_na.pdf .
Firmware Upgrade: Perform a software upgrade.
l
Load / Save Configuration: Enables saving or loading s ystem parameters from one
l
inverter to another.
Diagnostics: Displays the Isolation status and power optimiser status
l
screens. Refer to
https://www.solaredge.com/sites/default/files/application_note_
isolation_fault_troubleshooting.pdf.
Activate Standby Mode: Enables/disables Standby Mode - for
l
remote commissioning.
Grid Protection: Available in specific countries. Enables viewing and setting grid protection values.
l
Board Replacement: Backs up and restores the system parameters, including energy counters; Used
l
during board replacement according to the instructions supplied with replacement kits.
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter
45