SolarEdge SE66.6KUS Installation Manual page 63

Creating an Ethernet (LAN) Connection
NOTE
If using a cable longer than 10 m / 33 ft in areas where there is a risk of induced
voltage surges by lightning, it is recommend to use external surge protection
devices.
For details refer to:
protection.pdfhttp://www.solaredge.us/files/pdfs/lightning_surge_protection.pdf.
To connect the Ethernet cable:
1. Open the communication gland.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to ensure proper sealing.
Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne étancheïté.
2. Remove the rubber fitting from the gland and insert the CAT5/6 cable through the gland and through
the gland opening in the Connection Unit .
3. Remove the plastic seal from the large opening that has a cut in the rubber fitting.
62
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
http://www.solaredge.com/files/pdfs/lightning_surge_
Figure 37: Example of Ethernet connection