SolarEdge SE66.6KUS Installation Manual page 32

3. If you are not using the level:
Position the mounting brackets against the wall and mark the required drilling holes locations. The
distance between neighboring holes from different brackets should be 9 cm / 3-5/8"Figure 18 to
ensure a distance of 1.2" (3 cm) between inverter units.
NOTE
Make sure to maintain the required distance between brackets and units, otherwise the cables
connecting the Secondary Unit(s) to the Connection Unit may not reach the connectors.
If you are using the level:
a. Position the mounting brackets against the wall and mark the required drilling holes locations
with the supplied level. The level markings correspond to a distance of 3 cm between units.
b. Drill two holes for each bracket and mount the brackets.
c. Put in the screws without tightening in order to correct positioning.
d. Place the level beneath the brackets a nd align the brackets, tighten the screws all the way and
verify that the brackets are firmly attached to the mounting surface.
4. Mount the Primary Unit bracket and put in the screws.
5. Tighten the Primary Unit screws all the way and verify that the bracket is firmly attached to the
mounting surface.
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
Chapter 3: Installing the Primary and Secondary Unit(s)
Figure 18: Brackets spacing
Figure 19: Aligning the brackets
31