Cable Connection; Figure 16. Nvision Settings Window - Nonin WristOx2 3150 Operator's Manual

8. For more information, see nVISION Help.

Cable Connection

NOTE: To save battery life, the Model 3150 will automatically shut off after 60 minutes
when it is connected to a PC using the USB interface cable.
To connect the device to a PC, use the PC USB interface cable found in the starter kit. Once
connected to a PC, the device settings may be accessed and data can be downloaded using
nVISION software.
The USB driver software for the cable needs to be installed before the device can connect to
the PC. The software is located in the USB Driver folder on the Operator's Manual CD.
1. Install USB driver if needed. See appropriate "USB Driver Installation" section for more
information.
2. Connect the cable to the USB port on the PC.
3. Connect the cable to the device's sensor port.
4. When the device is ready to use with nVISION, these indicators display on the LCD:
• CP
• Battery indicator
5. For more information about nVISION, refer to nVISION Help.
NOTE: Disconnect the USB interface cable from the device when the data transfer or
device configuration is complete. Leaving the cable connected will reduce battery life.
30
Figure 16: nVISION Settings Window
nVISION Software