Connecting The Cable And Sensors; Turning On The Pulse Oximeter - Nonin 8600V Operator's Manual

Connecting the Cable and Sensors

Connect the interface cable (Model 8600VI) to the 9-pin female latching sensor connector on the front of the 8600V
shown in Figure I. Connect the sensor to the patient interface cable. Position the appropriate sensor on the animal.

Turning On the Pulse Oximeter

Turn on the 8600V by pressing the "" power switch on the front of the pulse oximeter. Refer to Figure I.
When the 8600V is powered on, the displays will cycle through the following sequence before displaying valid data
values:
•
" " (8600V) or "
•
current time in hours and minutes saved in memory
•
software revision number
•
" "
SELF
•
indicator illuminates
TEST
• SENSOR
indicator illuminates
•
indicator illuminates
If this sequence does not complete properly, do not use the oximeter. Call NONIN
NOTE:
Customer Support.
" (8600MV)
Figure I: Front View of the 8600V
7