Installing The Radar Card - Xycom 9450 Manual

Installing the CPU Board
1. Disconnect all power supplies.
2. Remove the three screws that secure the top cover to the slide-out computer module.
Certain mounting configurations require the slide-out computer module to be re-
moved (refer to Removing the Slide-out Module section earlier in this chapter).
3. Verify all jumper settings.
4. Hold cables FDD, HDD-I, COM1, COM2 and LED toward the side of the CPU
module.
5. Place the AT4+ CPU card into slot 0 in the passive backplane, or the AT5+ CPU
card into slot 1 in the passive backplane. Push the card ¾ of the way down.
6. Attach flat cables FDD, HDD-I, COM1, COM2, and LED to their respective con-
nectors on the CPU board. Push down the card evenly until it firmly seats into card
edge connector.
7. Connect the optional battery cable connector BAT-IN to the CPU board.
8. Secure the ORB with one screw at the top.
9. Close the top cover and replace and tighten the three screws. If the slide-out com-
puter module was removed in Step 2, refer to the Re-installing the Slide-out Module
section earlier in this chapter.
10. Connect the power sources previously disconnected.
The 9450 CPU is now ready for operation.
Removing the CPU Board
1. Disconnect all power supplies.
2. Remove the three screws that secure the top cover to the slide-out computer module.
Certain mounting configurations require the slide-out computer module to be re-
moved (refer to Removing the Slide-out Module section earlier in this chapter).
3. Remove and save the CPU board ORB screw.
4. Unseat the CPU board from the backplane. Pull the board up far enough to unlatch
and remove the connectors (about 1").
5. Remove cable connectors FDD, HDD-I, COM1, COM2, LED, and BAT-IN.
6. Once the cables are disconnected, pull the CPU board out of the slide-out computer
module.

Installing the RADAR Card

Before installing the 9000-RAD (RADAR card) into the 9450, set the appropriate jump-
ers and switches for your configuration. See the 9000-RAD manual for more informa-
tion.
After the RADAR card is properly configured, install it in the 9450 card cage as follows:
Chapter 2 - Testing
11