Quadtel Bios; Initiating The Tests; Preparing For The Tests - Xycom 9450 Manual

9450 Industrial PC/AT Computer System

Quadtel BIOS

If the CPU board has a Quadtel BIOS, press
Setup Menu. Follow the on-screen directions to make changes. Press
changes, and
Menu.

Initiating the Tests

You need the following equipment to test your system:
•
Xycom System Test Disk – 3.5-inch, DS/HD disk (bootable)
•
IBM PC/AT-compatible keyboard
•
Centronics-compatible printer cable
•
Parallel printer (Centronics-style interface)
•
Two serial loopback test connectors (refer to Figure 2-1 for pinout)
•
Scratch disk formatted 3.5 -inch, DS/HD (1.44 Mbyte)

Preparing for the Tests

Perform the steps below before starting the system test:
1. Place the CPU board jumpers and switches to the factory set positions. The numbers
in parenthesis are the pins onto which to install the jumper, (e.g. J1 (3-4) indicates
the jumper is on pins 3 and 4 of J1). Refer to your CPU manual for jumper and
switch settings.
2. Plug the female end of the AC power cable into the rear of the unit and the male end
into a properly grounded outlet.
3. Connect the video cable to the 15-pin connector on the CPU board.
4. Connect the PWR/key 15-pin cable to the Pwr/key female receptacle located above
the power receptacle.
5. Attach the monitor power cord from the monitor to the power receptacle
6. Connect the serial loopback connector(s) and the printer cable to the appropriate
connectors and connect a PC/AT-compatible keyboard to a keyboard connector. Fig-
ure 2-1 illustrates the wiring necessary for the loopback connection.
2-2
to exit. Refer to the CPU manual for more information on the Setup
ESC
+ + simultaneously to access the
CTRL ALT S
10 to save
F