Adjusting The Angle And The Height Of The Knife - Horizon Fitness PC-P430 Manual

1 - 2 Adjusting the Angle and the Height of the Knife

1 - 2 - 1 Adjusting the Angle and the Height of the Knife
1 Place the sheets. (Fig.1)
• Cut the sheets of 64 gsm (the common copy paper) into
strips, and place four sheets on the left end and one
sheet on the right end.
• The numbers of sheets differ between the right side and
left side because the left side of the knife cuts into the
sheets more deeply than right side (the left side of the
knife holder is pulled) when the machine cuts the sheets
actually. Therefore, the stack on the left side must be
higher by three sheets.
2 Set the Toggle switch on the QPW-968 to
"ADJ". (Fig.2)
→ The three LEDs at the monitor light up in order. The LED
L1 on the QPW-968 control board is lit.
(See Fig.7 on the next page.)
3 Press the Right and Left Cutting buttons.
• The knife will lower and stop at the lower limit.
4 Turn off the Key switch.
5 Adjust the height. (Fig.3)
• Loosen the lock nut, and adjust the height by turning the
adjusting screw so that the knife edge touches the top
sheet of the four sheets on the left side.
6 Adjust the angle. (Fig.4)
• Loosen the locking screw, and adjust the angle by turn-
ing the eccentric pin so that the knife edge touches the
sheet on the right.
(Continued to the next page.)
1
General
4 sheets on the left 1 sheet on the right
Fig.1 Placing the Sheets
Monitor
LEDs light up in order.
QPW-968 Control
Board Toggle Switch
ADJ
NORMAL
Fig.2 Toggle Switch on the Board
Adjusting the Angle and the Height of the Knife
Loosen
Lower
Loosen
Do not turn the adjusting screw more than ± 45 de-
grees from the factory setting position.
404018
1_2_1A
Fig.3 Adjusting the height
404018
1_2_1D
When you turn the eccentric pin using
the straight slot screwdriver, only the
right side of the knife moves down and
404018 up.
1_2_1B
Fig.4 Adjusting the angle
Right-hand Screw
Lock Nut
Adjusting
Screw
Left-hand Screw
Lock Nut
404018
1_2_1C
Locking Screw
Eccentric Pin
PC-P430
9