To display or modify the timeout interval, use the timeout command.
Does not change configuration
User password protected
If there is no activity from the user for a given amount of time (the timeout period), the system
automatically logs the user off. The value for the timeout period is displayed in seconds. The default
setting is 600 seconds. Any modification to this setting applies only to the user session in progress; once
the user logs off, the setting automatically resets to the default value.
The following example shows how to modify the timeout period setting.
edfa > timeout 500
The following example shows how to view the timeout period setting.
edfa > timeout
Timeout period is 500 seconds
Cisco ONS 15501 User Guide
This command was introduced.
Specifies the number of seconds for the timeout interval.
78-14134-01, Release 1.0