Help - Cisco ONS 15501 User Manual

help

help
To display the syntax for an individual command, or to display a list of available user commands, use
the help command.
Syntax Description
command
Defaults Displays a list of available user commands
Command Types Does not change configuration
Command Modes
User password protected
Command History Release
EDFA 1.0
Examples
The following example shows how to access a list of available user commands.
edfa > help
MAINTENANCE: boot-bank, ftp-burn, hide-trap, reboot, show-trap
The following example shows how to display the syntax for an individual command.
edfa > help help
USAGE: help [ <command> ]
If there is a command specified, the corresponding help for that command will be printed.
Without any command specified, a list of all commands will be shown.
Cisco ONS 15501 User Guide
4-14
help [command]
Modification
This command was introduced.
STATUS: Gain, GainMean, GainTrig, InPwr, InPwrMean, InPwrTrig, OptOutPwr,
OutAttn, OutSigPwr, OutSigPwrMean, OutSigPwrTrig, Temp, TempMean,
TempTrig, alarm, ps1, ps2, status
SETUP: SetGainMean, SetGainTrig, SetInPwrMean, SetInPwrTrig,
SetOutSigPwrMean, SetOutSigPwrTrig, SetTempMean, SetTempTrig
SYSTEM: add-snmp-com, add-snmp-mgr, del-snmp-com, del-snmp-mgr,
get-snmp-com, get-snmp-mgr, help, host-config, ip-config, logout,
ntp, ntp-ip, set-master-pwd, set-time, set-user-pwd, sys-info,
time, timeout
Specifies the command
Chapter 4 Command Reference
78-14134-01, Release 1.0