Settempmean - Cisco ONS 15501 User Manual

Chapter 4 Command Reference

settempmean

To modify the internal case temperature alarm mean level, use the settempmean command.
Syntax Description
mean
Defaults 30° C
Command Types
Changes configuration
Command Modes
Master password protected
Command History Release
EDFA 1.0
Usage Guidelines The internal case temperature mean is measured in degrees Celcius. The system accepts a minimum
value of 10°C and a maximum value of 90°C. If a value entered falls outside of this acceptable range,
the command will be ignored and have no effect.
Examples The following example shows how to modify the internal case temperature alarm mean level.
edfa > settempmean 29.00
Related Commands Command
resetmeantrig
settemptrig
temp
tempmean
temptrig
78-14134-01, Release 1.0
settempmean mean
Modification
This command was introduced.
Description
Resets the signal gain and alarm mean level, gain alarm trigger level, optical
input alarm mean level, optical input alarm trigger level, output signal alarm
mean level, output signal alarm trigger level, internal case temperature
alarm mean level, and internal case temperature alarm trigger level to the
manufacturer's default settings.
Sets the internal case temperature alarm trigger level.
Displays the internal case temperature level.
Displays the internal case temperature alarm mean level.
Displays the internal case temperature alarm trigger level.
Specifies the desired internal case temperature alarm mean level.
settempmean
Cisco ONS 15501 User Guide
4-43