To modify or display the NTP (Network Time Protocol) status for the system, use the ntp command.
Displays the current configuration of the NTP (that is, on or off), as well as the current IP addresses of
the primary and secondary NTP servers
User password protected
The following example shows how to enable the NTP for the system.
edfa > ntp on
The following example shows how to display the current configuration of the NTP.
edfa > ntp
ON, 220.127.116.11, 18.104.22.168
Cisco ONS 15501 User Guide
This command was introduced.
Modifies the IP addresses of the NTP server.
Specified as on to enable the NTP, or as off to disable the NTP.
78-14134-01, Release 1.0