Installing An Sd Card; Removing An Sd Card - Honeywell AutoRAE 2 User Manual

Installing an SD card

1. Use a 2.0-size hex wrench to loosen and remove the screw holding the cover on the SD
card port.
2. Slide the door down so that the port is visible.
3. Press the SD card into the slot with the angled notch on the right. Press until it locks into
place, making a "click" sound. Slide the door up to cover the port.
4. Insert and tighten the screw.
Loosen the hex screw that secures the cover
Slide the cover down

Removing an SD card

To remove an SD card, press in on it until it makes a click and pushes part of the way out of the
slot. Then pull it out with your fingers.
AutoRAE 2
Remove the hex screw
Press the SD card into the slot until it clicks
88 User Manual