Cabinet construction
Contents of this chapter
This chapter instructs in placing the modules and additional equipment into a cabinet.
For general instructions, see Cabinet design and construction instructions for drive modules
(3AUA0000107668 [English]).
Limitation of liability
The installation must always be designed and made according to applicable local laws and
regulations. ABB does not assume any liability whatsoever for any installation which breaches
the local laws and/or other regulations. Furthermore, if the recommendations given by ABB
are not followed, the drive may experience problems that the warranty does not cover.
General
See the technical data for module-specific cooling requirements and allowable mounting
orientations.
Installation examples
WARNING!
The code labels attached to mechanical parts such as busbars, shrouds
and sheet metal parts must be removed before installation as they may
cause bad electrical connections, or, after peeling off and collecting dust
in time, cause arcing or block the cooling air flow.
This section instructs in placing the modules and additional equipment into a user-defined
cabinet.
Cabinet construction 45
4
10