Therapy Using Medium-Frequency Current Modes; Pain Therapy, Hyperaemisation, Detonisation Using Amf Current - Physiomed IONOSON-Jubilee Operating Instructions Manual

Stimulation Current Therapy
Note If the intensity (intensity control <6> ) is turned up during the time
of release, the following message will appear in the lower status
bar <4>:
Slowly turn down the intensity then. The message
will disappear as soon as the previously set value is reached again.
4.6

Therapy using medium-frequency current modes

4.6.1 Pain Therapy, Hyperaemisation, Detonisation using AMF Current

Treatment Procedure
(1) Attach the electrodes to the respective stimulation points.
(2) Select the current mode
(3) Depending on the indication, select a frequency band or a fixed frequency.
(4) If necessary, alter the basic frequency.
(5) Set the therapy time.
(6) If necessary, plug in the manual release key as therapy pause button.
(7) Slowly turn up the intensity with intensity control <6>). The therapy time elapses.
Warning Take care that the electrodes are by no means touched after the current is
turned up!
(8) After treatment, an acoustic signal will be issued.
Turn the intensity down to 0.
(9) Remove the electrodes.
32
from the display <3>.
AMF
IONOSON-Jubilee