Table of Contents
Advertisement
Procedure
(1) Attach the electrodes to the respective stimulation points (bipolar or unipolar mode of
attachment).
(2) Select the menu
(3) Select the menu
(4) Activate the acoustic signal, if desired.
a) Set the Square-wave Impulse Characteristics (RIC)
(1) Select the desired initial pulse time T (1000 or 500ms).
(2) Select the release time
mand button
(3) Slowly turn up the intensity with the intensity control <6> until the muscles show
signs of tension. Watch for the pauses between the pulses.
Warning When using the manual release key, release a pulse each time you turn up
the intensity!
Warning Take care that the electrodes are by no means touched after the current is
turned up!
(4) Press the button
saved automatically. The pulse time
value.
(5) Slowly turn up the intensity again until the muscles show signs of tension. Press the
button
REACTION
(6) Repeat this cycle until all pulse times T or only the desired ones have elapsed.
(7) Turn the intensity down to 0.
IONOSON-Jubilee
.
DIAGNOS.
.
I/T-CURVE
(2-5 s or manual release key). Move the cursor to the com-
R
.
REACTION
to confirm the intensity value. The intensity value will be
REACTION
to confirm the intensity value again.
is switched automatically to the next lower
T
Diagnosis using Stimulation Current
35
Advertisement
Table of Contents
