Table of Contents
Advertisement
Controls and Indicators
2.3 Operation
Selecting a function (e.g. the current mode
to level 2 of the menu. Here you can set the desired parameters for the selected current
mode.
The following functions are available on level 2:
The parameters of the menus
later.
2.3.1 Parameters for Stimulation Current
The following paragraph will give you an overview of the meaning of the symbols in the
menus for the individual current modes.
In General
The symbols below apply for all current modes with low frequencies:
Current Mode
10
Memory menu; individual programs (single treatments or current
modes) can be memorised.
Display electrodes: Indicates whether the current is released via plate
electrodes (this symbol) or via vacuum electrodes. The vacuum elec-
trodes are enabled automatically when switching on the vacuum de-
vice. When the vacuum device is switched off, the current is released
via plate electrodes (switching is slightly delayed).
Setup menu (settings)
Back to level 1
Therapy timer with selected therapy time; the therapy current
will be reduced to 0 and an acoustic signal will be issued
every 10 seconds after the countdown (left timer: stimulation
current, right timer: ultrasound).
,
DIAGNOS.
Intensity display (mA), to be set with intensity control <6>.
The sign (plus/minus) signifies the polarity of the red plug.
Exchange of polarity of the two electrodes; the sign (plus/minus) of
the intensity display will be changed respectively.
G
Switching from galvanic current to medium-frequency interrupted
direct current. The current setting is displayed in the upper status bar.
) from the start menu (level 1) will lead you
G
,
and
INDICAT.
INDIVID.
Toggling intensity ranges (0 – 3.5 mA or 0 – 25
mA). The current setting is displayed in the up-
per status bar (only for
will be discussed
SETUP
).
G
IONOSON-Jubilee
Advertisement
Table of Contents
