Table of Contents
Advertisement
Treatment Procedure
(1) Use an alcoholic swab to remove cutaneous fat. Take care that there are no skin le-
sions in the area of treatment.
Preparing the skin with heat before the treatment will improve its receptiveness.
(2) Apply the ointment, cover it with iontophoresis foil and put on the moistened viscose
covers with the electrode inside.
(3) Fix the electrode to the point of treatment. Moisten the viscose cover of the opposite
electrode sufficiently with water and fix it as well.
(4) Select the current mode
electrodes!
(5) Set the therapy time.
(6) If necessary, plug in the manual release key as therapy pause button.
(7) Slowly turn up the intensity with the intensity control <6>. The therapy time
elapses.
Warning Take care that the electrodes are by no means touched after the current is
turned up!
(8) After treatment,, an acoustic signal will be issued.
Turn the intensity down to 0.
(9) Remove the electrodes and rinse the viscose covers thoroughly.
Note
The diffused quantity of the agent directly depends on the size of the elec-
trodes, the therapy time and the current intensity. During galvanisation the
maximum current intensity is 0.1 mA on 1 cm² of active electrode area.
The time of each treatment must always be chosen according to medicament and size of
electrodes; one treatment typically lasts 10-30 minutes.
4.5.3 Pain Therapy, Hyperaemisation, Detonisation
The following current modes can be used for these modes of therapy:
,
,
,
,
G
DF
MF
CP
LP
Treatment Procedure
(1) Attach the electrodes to the respective stimulation points .
(2) Select one of the above-mentioned current modes from the display <3>, e.g.
(3) Select the variable parameters (e.g. frequency, biphase, etc.).
(4) Set the therapy time.
IONOSON-Jubilee
from the display <3>. Watch for correct polarity of the
G
,
,
,
,
,
UR
HV
TENS
IG 30
,
,
.
IG 50
FM
STOCH
Stimulation Current Therapy
.
STOCH
29
Advertisement
Table of Contents
