Table of Contents
Advertisement
2.3 Operation
Selecting a function (e.g. the current mode
to level 2 of the menu. Here you can set the desired parameters for the selected current
mode.
The following functions are available on level 2:
The parameters of the menus
later.
2.3.1 Parameters for Stimulation Current
The following paragraph will give you an overview of the meaning of the symbols in the
menus for the individual current modes.
In General
The symbols below apply for all current modes with low frequencies:
Current Mode
PHYSIOMED-Jubilee
Memory menu; individual programs (single treatments or current
modes) can be memorised.
Display electrodes: Indicates whether the current is released via plate
electrodes (this symbol) or via vacuum electrodes. The vacuum elec-
trodes are enabled automatically when switching on the vacuum de-
vice. When the vacuum device is switched off, the current is released
via plate electrodes (switching is slightly delayed).
Setup menu (settings)
Back to level 1
Therapy timer with selected therapy time; the therapy current
will be reduced to 0 and an acoustic signal will be issued every
10 seconds after the countdown (left timer: stimulation cur-
rent).
DIAGNOS.
Intensity display (mA), to be set with intensity control <6>.
The sign (plus/minus) signifies the polarity of the red plug.
Exchange of polarity of the two electrodes; the sign (plus/minus)
of the intensity display will be changed respectively.
G
Switching from galvanic current to
rupted direct current
per status bar.
Toggling intensity ranges (0 – 3.5 mA or 0 –
25 mA). The current setting is displayed in the
upper status bar (only for
) from the start menu (level 1) will lead you
G
,
,
INDICAT.
INDIVID.
medium-frequency inter-
. The current setting is displayed in the up-
Controls and Indicators
and
will be discussed
SETUP
).
G
9
Advertisement
Table of Contents
