86
7.7
Inserting the machine head
WARNING
Risk of injury!
The machine head is heavy and can cause
crushing injuries if handled in a careless manner.
NEVER stick your hands between machine head
and tabletop.
Fig. 44: Inserting the machine head
①
②
(1) - Machine head
(2) - Upper hinge parts
Important
Remove the supporting screws (4) before inserting hte machine
head.
To insert the machine head:
1.
Fit the machine head (1) from above at an angle of 45°.
2.
Insert the upper hinge parts (2) into the rubber inlays (3).
3.
Tilt the machine head (1) and insert it in the recess.
③
(3) - Rubber inlays
(4) - Supporting screws
Operating Instructions 275 - 02.0 - 08/2019
Setup
④