DURKOPP ADLER 275 Series Operating Instructions Manual page 97

Setup
Operating Instructions 275 - 02.0 - 08/2019
Continue switching the sewing sequence via thread cutting
When sewing multiple widths in a program the next sequence is
usually activated by cutting the thread. 3 methods of switching the
next sequence via thread cutting are available:
To continue switching the sewing sequence via thread cutting:
1. After calling up the special functions, press sequence button 5.
 The display (3) shows the A5 selection:
2. Select the desired setting using the buttons
• Thread cutting does not switch to the next sequence:
Set the display to 00.
• Thread cutting does switches to the next sequence:
Set the display to 01.
• Switch to the next sequences after every thread cut-
ting operation and after 2 thread cutting operations
when automatic direction changing is setin the 1st and
the last sequence (the 1st thread cutting operation trig-
gers the direction change, the 2nd thread cutting opera-
tion activates the next sequence): Set the display to 02.
Information
The machine is set to 02 when delivered.
3. Save the desired Setting by pressing the button
 The LED above the button goes out.
The system switches out of the special function mode back
into normal operation.
:
twice.
95