Edge Cutter; Setting The Edge Cutter Without A Dac Mini - DURKOPP ADLER 275 Series Operating Instructions Manual

44

4.12 Edge cutter

The lowering and raising of the edge cutter is defined via the
parameter settings in the control ( Operating manual
DAC basic/classic).
The cutting speed of the edge cutter is defined via a 3-position
switch. The positioning of the switch depends on whether or not
the DAC mini control is used.

4.12.1 Setting the edge cutter without a DAC mini

On machines without a DAC mini the switch for the edge cutter is
located on the machine arm. The LED lights up green when the
machine is switched on.
Fig. 24: Setting the edge cutter without a DAC mini
①
(1) - LED edge cutter
(2) - LED edge cutter
To set the edge cutter without a DAC mini:
1. Set the switch (3) to the desired position:
• switch off the edge cutter: Position 0
 LEDs (1) and (2) are off.
• low speed: Position I (for small to medium stitch lengths)
• high speed: Position II (for medium to large stitch
lengths)
 After moving the switch (3) to position I or II the LED (2) flas-
hes. At the start of sewing the edge cutter switches on auto-
matically after the 1st stitch.
The LEDs (1) and (2) light up constantly while the edge cut-
ter is working.
② ③
(3) - Switch
(4) - LED machine on/off
Operating Instructions 275 - 02.0 - 08/2019
Operation
④