5. Installing machine head
5.1 Insert machine head
–
Insert machine head 1 into the cut-out of the table top.
5.2 Fitting the keys
The tension plate has 3 threaded holes for fastening the keys.
–
Fasten the key 11 to the tension plate by 2 screws as shown in the illustration on
side 10. Two screws are included in the accessories.
2 positions are possible. In the right hand position there is more space at the lever
for connecting and disconnecting the needles.
–
Remove the bobbin cover and pass the incoming cable through its duct.
–
Pass the plug through the table top cut-out and introduce into the bush B3 of the
drive controller.
5.3 Placing and tensioning the V-belt
Remove the safety devices
–
Remove the belt guard cover 6 from the sewing motor.
Place V-belt in position and fit belt guard 3 on the machine head
–
Fasten belt pulley 8 (in the accessories) on the shaft of the sewing motor.
–
Place the V-belt 4 through belt guard on the belt pulley 2 of the machine head.
–
Pass the V-belt 4 down through the cut-out in the table top.
–
Tilt the machine head backwards.
–
Place the V-belt 4 onto the belt pulley 8 of the sewing motor.
–
Return the machine head into its initial position..
When tilting, the belt guard should freely enter the cut-out in the table top.
–
Screw up the belt guard on the machine head.
Tensioning the V-belt
–
Loosen the screw 7 on the base of the sewing motor.
–
Tension the V-belt by swinging the sewing motor 9.
When the tension of the V-belt is correct and when the belt is pressed in its middle
(without any excessive force) it must yield inwards about 10 mm.
–
Re-tighten the screws 7.
9