Setup
Operating Instructions 275 - 02.0 - 08/2019
7.4
Tabletop
Ensure that the tabletop has sufficient load-bearing capacity and
strength.
7.4.1
Completing the tabletop
Fig. 36: Completing the tabletop (1)
②
③
④
(1) - Machine head support
(2) - Pubber inlays
(3) - Rest plugs
To complete the tabletop:
1.
Insert the machine head support (1) into the holes in the table
plate.
2.
Fit the rubber inlays (2) into the recesses.
3.
Insert the rest plugs (3) and slide on with compression springs.
4.
Screw the drawer (4) under the table plate at the left.
5.
Screw the cable duct (5) under the table plate at the rear.
6.
Center punch the screw positions of the oil pan (6) and screw
the oil pan into position under the table plate cutout using
wood screws.
①
⑤
(4) - Drawer
(5) - Cable duct
(6) - Oil pan
⑥
77